In my quest to become a better poker player, I thought I would look at some other ways to improve my skills. One of the things I found out is that I needed to get a better idea of how to make cattle poker sticks. Here are some tips on how to make your own poker chips.
The first thing you need to know is how to make your own homemade cattle poker chips. First, gather up some pieces of wood, cardboard, and glue. You’ll also need some sort of marking knife and a piece of measuring tape. Remember to not be overly concerned about messing it up!
Remember, you don’t have to do a whole thing with this. Just make a cut on the ends of the cardboard and wood. Make a cut on one end and then connect the two together by screwing it together. Then you can secure the other end with the screw.
Next, you can drill a hole on one end so that the screws can come through it. Have your measuring tape at this point and start drawing lines and measurements. If you’re thinking this is too easy, you’re wrong. It’s really hard, but if you’re like me, then you will do it. It only takes a couple of minutes to finish this task.
Now, you can use a pencil and the lines and measurements to cut different shapes. Don’t worry, because if you mess it up it won’t be very expensive. If you have a wooden mallet, then just use that.
Also Read: How to have a Poker Face
If you’re going to be using sandpaper, you should also use it for the edges. This is a very important step because you want to make sure the edges don’t get crushed when you’re hitting the ball with it.
You can also use a stud finder to mark the studs on the cattle poker. Take the stud finder and place it on the wrong side of the cattle poker. Then, take the top of the cattle poker and use the stud finder to trace around the studs.
After you’ve marked the studs, you can now begin the drilling. You may need to use a hammer or a screwdriver to pry the cattle poker off the cardboard.
Last, but not least, use the wooden mallet to tap the marks in the edge. Now you can easily attach the piece of measuring tape and screw the piece together. Be careful when you’re screwing it.
After you’re done, you’ll need to find the edge of the board and snap a hinge off it. Put the hinge on the side of the cattle poker and make sure the board isn’t touching the poker. Then, screw the finishing nails into the end of the cattle poker.
Now that you have homemade cattle poker sticks, you can use them for a number of ways. I’ve tried a lot of these cards and really like them. You can go through your cards a couple of times before you actually place the final nail into the last stud.
These homemade cattle poker sticks really give you an edge when you’re playing. I think you’ll be glad that you put in the extra effort.
